In order to exert the performance level of the machine, achieve the best use effect, and then extend the service life of the equipment, and the correct maintenance of the equipment in the daily use process is essential, the routine maintenance requirements and measures can refer to the following regulations

1. The operator must be specially trained before taking up the post.

2. Assign professional trained maintenance personnel to maintain.

3. Maintenance personnel must read and be familiar with this operation instruction before repair or maintenance.

In the long-term use of the equipment, some minor faults are inevitable, as long as the correct response method is mastered,
the site can be easily solved, which will help the equipment to maintain good working conditions, improve work efficiency,
and greatly shorten the equipment downtime. The following are some troubleshooting measures that this machine may encounter

Remove the ceramic pump core to clean, pay special attention to the cleaning process please use towels, toilet paper or other items to scrub. The correct method should only be rinsed with a liquid such as alcohol, water or DMC. If the card is very tight, the ceramic plunger rod needs to be removed with the special booster pump designed by Ji kerr. To prevent this phenomenon, install a filter on the liquid source to filter the liquid.

The main component of alumina ceramics is Al2O3, and the company uses 996 alumina. Alumina ceramics have various excellent properties. High temperature resistance,
generally can be used for a long time at 1600℃, corrosion resistance, high strength, high wear resistance. It is widely used in ceramic substrates, structural ceramic parts, sealing rings, etc

Ji Kerr injection pump of the pump head selects the acid and alkali resistance,
high temperature resistant material. Suitable for use in most harsh environments.
Easy to disassemble and assemble in just 5 minutes.

Ordinary lithium-ion batteries produce a small amount of gas inside the battery during the charging process,
which is generally absorbed during discharge. If the charging current is too large and often overcharged, the gas generation will be intensified,
and the internal pressure of the battery will increase resulting in swelling. A slight bulge in the battery is allowed,
and avoiding overcharge is the key to reducing the bulge phenomenon. In the production process of the battery cell liquid injection,
the requirement of liquid injection pump is high.

Lithium-ion battery production liquid injection production link has been close to the bottleneck, Ji kerr's original small-stroke electronic liquid injection pump,
the capacity is difficult to meet the power of large-capacity battery electrolyte injection. In order to meet the market and customer needs